<====:script cmd=new_a_block_s_script mcu=stc8#stc8g#stc12 block_type=at24cxx_send_byte block_message0=i2c记忆芯片AT24Cxx %1.num.field.dev_no_to_use=i2c_at24c04_maps 在地址: %2.num.input.addr=Number处写入数：%3.num.input.dat=Number (0-255) block_group=元件库-储存器.$pname$ min_need_ver=1.23 is_block1_or_input2=1 colour=180 input_out_type=Number <--cs.code[ AT24CXX_WriteOneByte_$rnd_varname_pre$([($_xgm$addr),type=num],[($_xgm$dat),type=num]); ]--> <--shared_func_In_main_c[ @@check_func_is_exist_ed=float2char_003 #get_global_codes(group_xml,rand1,block_name,ref_complier,extinfo,"float2char_003","float2char",true,"","","","")% ]--> ====> <====:script cmd=new_a_block_s_script mcu=stc8#stc8g#stc12 block_type=at24cxx_read_byte block_message0=i2c记忆芯片AT24Cxx %1.num.field.dev_no_to_use=i2c_at24c04_maps 在地址: %2.num.input.addr=Number处读一个字节 block_group=元件库-储存器.$pname$ min_need_ver=1.23 is_block1_or_input2=2 colour=180 input_out_type=Number <--cs.code[ AT24CXX_ReadOneByte_$rnd_varname_pre$([($_xgm$addr),type=num]) ]--> <--shared_func_In_main_c[ @@check_func_is_exist_ed=float2char_003 #get_global_codes(group_xml,rand1,block_name,ref_complier,extinfo,"float2char_003","float2char",true,"","","","")% ]--> ====> /* <====:script cmd=new_a_block_s_script block_type=drv_pul_width_init3a block_message0=脉宽测量器(测正脉冲宽度,占用timer1模式，精度 5us,主频请配置成24Mhz以上才准) %1.num.field.dev_no_to_use=pul_width_maps 初始化， 脉冲输入引脚：%2.pin.field.pins=INT0_INT1_maps block_group=元件库-显示器.$pname$ min_need_ver=2.555 is_block1_or_input2=1 colour=180 input_out_type=Number <--toolbox_code_if_not_empty.code[ ]--> <--cs.code[ is_geted_pul_start_ed_$rnd_varname_pre$=0; is_geted_pul_end_ed_$rnd_varname_pre$=0; pul_width_$rnd_varname_pre$=0; Fpul_width_$rnd_varname_pre$=0; ]--> ====> last_run_newblcok_script_update_time.ini设置1999-01-01则编译时更新 */